There's 8 sheets to work with, 7 of which contain dimensioned drawings for all the individual components. They're designed to take advantage of common sizes when working with paper, so you'll see a lot of 3.175mm and 6.35mm diameter holes and tubes, corresponding to a 1/8" and 1/4" hole punch. Easier than cutting a 6mm circle by hand. Best built using 110lb cardstock and Magic: the Gathering cards.
Sheet 1: Deals with the center support post.
Sheet 2: Front legs and rear supports
Sheet 3: Mounting plate for miniguns and ammo drum
Sheet 4: Ammo Drum
Sheet 5: Rocket Turret assembly
Sheet 6: Miniguns
Sheet 7: Rear legs
Sheet 8: Miscellaneous Assemblies
Next time: tips on weight reduction and building techniques using these diagrams!
3 comments:
What's the mtg?
That's specifying to use Magic the Gathering cards or equivalent for structural purposes. 110lb cardstock isn't strong enough for this model.
Thank you so much, I'm working on a solid works model and I couldn't figure out what that was. It's silly because I play it ^^;
Post a Comment