Kshatriya + Obitsu Stands = Fun

 I recently purchased a 1/144 HGUC Kshatriya from the Gundam Unicorn series. One of the comments I've seen floating around is that there's no means provided to display all 24 of the funnels. It's a shame, as you can't have the full glory of Kshatriya annihilating enemies with an overabundance of laser spam. All I've seen people do with their kits is pose them in the usual flight config with an Action Base, or standing on a table. Nothing with the funnels. How hard could it be to display them all?

A while back, I had bought three Obitsu Multi Purpose Clear Stands to try out. I was quite pleased with their performance. I had recently bought three more because they were that awesome. This is my 6th and last unassembled stand that I was saving up until now. Where are we going with this? We'll find out!

 I discovered something about the funnel's attachment point to the wing binders and the shape of the Obitsu grabbing claw tips: they snugly fit with each other without modifications. Each stand comes with two grabbing claws. Theoretically, each stand can hold four funnels. I already have six Obitsu stands. Worked out better than I expected.

 

With some fiddling with the arrangement, you can finally have your Kshatriya with all funnels fully deployed. Too bad I have nothing that requires 24 funnels to kill. I did come across another problem that this configuration brings: I don't have 24 beam effects of the same color. Per the series, all the beams are green. Kshatriya comes with two beam sabers, which provides... two beam effects. Still 22 short. Luckily, like a pack rat, I kept the runners.
 

The best I could do was to cut up the runner to form two additional beam parts. 

Using the stand itself to support the beam, and the tip of the funnel itself, you can get mid-shot effects with some mounting tack. I sure don't have more stands to hold up these beams by themselves, and this method worked out quite well.

 Can you say, "screwed"? 

This was the first instance I had where I used every single type of stand I owned to do a single photo: six Obitsu Stands, one MMS stand (for the Zephyrantes), and an Action Base. This setup also takes up an ungodly amount of room to display, which is a shame since I'd like to keep this display on my shelf. It does need more beam effects though.

For a low budget method, you can just use black/white electrical wire and mount the funnels to the tips. Although, you'd need to fashion some weights to hold them down. The cost of six Obitsu stands is practically the cost of Kshatriya itself, so I wouldn't suggest anyone to go out and buy them just for this purpose. Although I don't think any Gunpla builder would have these stands to begin with.